Sequencer

Action Sequencer

The Action Sequencer plugin can record the modeling operations (Subdivisions and Face modifiers) and replay the action sequence. The plugin interface allow to change the values applied for each command, disable a command and provide an easy to use parametric modeling interface for GEM.

Every command is documented in a single row. A row contain 4 columns: On/Off, Action, Parameters and Switch.

The Parameters Column stores the values assigned to the modeling action. The switch stores the toggles status.

1. Recording a Sequence

- Load the initial Mesh Geometry

- Press the Record Button to start. Every Command will be documented into the Action Sequencer.

2. Press Stop to end the recording session

3. Editing the Actions Records

- Mute by clicking on the left column (an "X" mark will appear, click again to activate)

- Edit any values you want to change (in the parameters and Switch column)

Note: It is recommended to disable the Weld and Unweld records that were created by the Subdivision algorithms.

4. Playing the Sequence

- Press the Rewind button to roll back to the model to its starting point:

- Press Play to Apply the Actions

5. Applying to a Different Geometry

- Load the new Mesh

- Apply Target Points (if required for proximity based actions).

- Press Play