Map by Rule

Create Face Map based on proximity to targets, height or random pattern. The Face Map is created between the predefined range from 1-10, indicated by color range of the components pallet.

Steps

1. Load different components into the blank colored cells (between 1-10) in the components pallet according to the amount of component you wish to populate.

2. Select a Mapping option (by Targets, by Height, Random).

   Note: For the Map by Targets method, first place target points along the mesh.

3. Type the components range according to the components you wish to populate. The numbers represents the components colored cells (Red=1, Orange=2, Yellow=3 etc.)

4. Press the create map button.

Options

• Mapping By Targets - Generates a population map that derives from the proximity to the target points. The red color (cell no.1) is located closest to the target points.

In this example the color values set between 1 to 8

• Revert the Population Pattern - To revert the colors distribution according to the target points swap between the cells numbers, as shown in the following example.

In this example the color values set between 8 to 1

• By Height- Creates population map referring to the mesh height. Red cells = Lower mesh area.

• Random - Create population map based on random layout

Command Activation Methods

• Interface (GUI)

Note : Select the Map by Rule method from the drop sown menu.

• Menu

Components > Population Map > Assign by Rule

• Command Line

Map

• Keyboard

Copyright © <2008-2011>, <Dr. Eyal Nir>